Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

REPAIR TCM PROGRAMMING

NOTE:

This DTC is set when a TCM from another vehicle is installed or a new TCM is installed into the current vehicle.

Perform the TCM PROGRAMMING PROCEDURE, PROXI Configuration Alignment, and VIN Verification procedures. Refer to STANDARD PROCEDURE .
Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
Did this DTC set after performing the TRANSMISSION VERIFICATION TEST?

Yes

NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals and connectors for corrosion, damage or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace the TCM and perform programming and PROXI Configuration Alignment procedures. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
No
- Test complete.