Diagnostic Test

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Start the engine.
2. With the scan tool, read Adaptive Cruise Control (ACC) Module DTCs and record on the repair order.
  Is the DTC active?
  
  Yes
  - Replace and program the Adaptive Cruise Control (ACC) Module in accordance with the Service Information. Refer to MODULE, ADAPTIVE CRUISE CONTROL (ACCM), REMOVAL .
  - Perform the ADAPTIVE CRUISE CONTROL VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this Module. Wiggle the wiring and connectors while checking for shorted and open circuits.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ADAPTIVE CRUISE CONTROL VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.