Pump, Windshield Washer: Installation: Headlamp
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new rubber grommet seal/filter screen into the headlamp washer pump/motor unit mounting hole in the washer reservoir (1). Always use a new rubber grommet seal on the reservoir.
- Position the inlet nipple of the headlamp washer pump/motor unit (3) to the rubber grommet seal/filter screen in the reservoir.
- Using hand pressure, press firmly and evenly downward on the headlamp washer pump/motor unit until the inlet nipple is fully seated in the rubber grommet seal/filter screen in the pump mounting hole of the reservoir.
- Using hand pressure, press the top of the headlamp washer pump/motor housing firmly inward far enough to engage the snap fit between the motor housing and the molded motor receptacle in the reservoir.
- Connect the Front End Module (FEM) wire harness connector (2) to the connector receptacle on the top of the pump motor.
- Connect the headlamp washer high pressure supply line quick connect fitting to the headlamp washer pump outlet quick connect nipple. Refer to HOSES AND TUBES, WASHER, STANDARD PROCEDURE .
- Install the plastic push-in fasteners that secure the left front wheelhouse splash shield to the inner fender panel and the front fascia. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
- Remove the support and lower the vehicle.
- Fill the washer reservoir with the washer fluid drained during removal.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.