Hoses And Tubes, Washer: Description: Headlamp

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

The headlamp washer system plumbing consists of a large diameter high pressure rubber supply line that is routed from the outlet nipple of the headlamp washer pump/motor unit on the washer reservoir to one barbed nipple of a wye fitting behind the center of the front fascia. The other two barbed nipples of the wye fitting are connected to two short lengths of supply line that each terminate at a headlamp washer nozzle behind the fascia and below the two front lamp units. The supply line connections at the nozzles and at the headlamp washer pump are secured using molded plastic quick-connect fittings.

Washer hose or tube is available for service only as roll stock, which must then be cut to length. The molded plastic washer plumbing fittings and routing clips cannot be repaired. If these fittings or clips are ineffective or damaged, they must be replaced.