LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Ignition System (Service Information)) >> Plug, Glow >> Removal

Plug, Glow: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the engine cover. Refer to .
    GC0169960Courtesy of CHRYSLER GROUP, LLC
  3. Clean the glow plug bay area.
  4. Disconnect the glow plug wire harness connector (1).
    GC0170037Courtesy of CHRYSLER GROUP, LLC
  5. Remove the glow plug (1) from cylinder head.
scientia non olet · About LEMON Manuals