LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Ignition System (Service Information)) >> Capacitor, Ignition >> Installation >> 3.2L

Capacitor, Ignition: Installation: 3.2L

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0154074Courtesy of CHRYSLER GROUP, LLC
  1. Position capacitor (2) to the rear of the cylinder head.
  2. Tighten nut (3) to 7 N.m (60 in. lbs.).
  3. Connect the wire harness connector (1) to coil capacitor.
  4. Install the main engine harness retainers onto the intake manifold.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals