Switch, Remote Radio: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Route the remote radio switch wire harness through the appropriate slot (2) in the steering wheel and connect the wire harness connector (1).
- Position the steering wheel bezel to the steering wheel.
- Connect the speed control switch wire harness connector (3).
- Connect the Electronic Vehicle Information Center (EVIC) switch wire harness connector (1).
- Install the two steering wheel bezel retaining screws (2) and securely tighten.
- From the back of the steering wheel, install the two screws (2) that secure the lower steering wheel bezel (1) and securely tighten.
- Install the left and right steering wheel bezel screws (2) and securely tighten.
- Install the left and right switch (1) into the steering wheel opening (3).
- Install the left and right switch (1) screws (2) and securely tighten.
- Install the left and right remote radio switch covers (1).
- Install the driver air bag. Refer to AIR BAG, DRIVER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.