LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Audio/Video/Entertainment/Connectivity (Service Information)) >> Module, Radio Antenna >> Installation

Module, Radio Antenna: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0177025Courtesy of CHRYSLER GROUP, LLC
  1. Position the radio antenna module (2) into place on the driver side C-pillar.
  2. Install and securely tighten the screw (1).
    GC0176899Courtesy of CHRYSLER GROUP, LLC
  3. Connect the antenna cable (1) to the radio antenna module (2).
    GC0177023Courtesy of CHRYSLER GROUP, LLC
  4. Connect the two wire harness connector (1) to the radio antenna module (2).
  5. Install the driver side upper quarter trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals