Inner Tie Rod
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the outer tie rod. Refer to TIE ROD, STEERING, REMOVAL .
- Remove the tie rod adjuster jam nut from the inner tie rod.
- Remove the clamp (2) securing the bellows (1) to the steering gear body.
- Remove the clamp (3) from the small end of the bellows and remove the bellows (1) from the gear.CAUTION:
If the inner tie rod cannot be removed using the specified tools, do not use a hammer or heat to loosen. Damage to the steering gear will occur. Replace the entire steering gear.
- Install an appropriate inner tie rod removal tool on the flats of the inner tie rod.
- Unthread and remove the inner tie rod from the steering gear (1).
- Inspect the inner portion of the gear for corrosion, contamination, and damage. If any is found, replace the steering gear.