Section 58 (Propeller Shaft): Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Propeller shaft removal is a two-person operation. Never allow propeller shaft to hang from the center bearing, or while only connected to power transfer unit (PTU) or rear driveline module flanges. A helper is required. If a propshaft section is hung unsupported, damage may occur to the joint, boot, and center bearing from over-angulation. This may result in driveline vibrations.

Place transmission in neutral.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Apply index marks (3) on the rear pinion flange and the rear propeller shaft flange.
NOTE:
Be sure a helper is holding the propeller shaft in place.
Remove and discard the propeller shaft bolts (1) at the rear pinion flange.

Courtesy of CHRYSLER GROUP, LLC
Remove the front center bearing bolts (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the rear center bearing bolts (1).

Courtesy of CHRYSLER GROUP, LLC
Slide the propeller shaft (1) off the Power Transfer Unit (PTU) and remove the propeller shaft from the vehicle.