2.0L Diesel
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the engine cover. Refer to the appropriate service article
.
- Remove the clamp (2) and the crankcase breather hose.
- Disconnect the crankcase vent heater wire harness connector (4).
- Remove the clamps (3) and carefully pull up on crankcase vent heater from turbocharger air inlet hose (4) and breather hose.