LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Emissions Control) >> Evaporative Emissions, Diesel >> Heater, Closed Crankcase Ventilation (CCV) >> Installation >> 2.0L Diesel

2.0L Diesel

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0157481Courtesy of CHRYSLER GROUP, LLC
  1. Install the crankcase vent heater into turbocharger air inlet hose and breather hose and tighten the clamps (3).
  2. Connect the crankcase vent heater wire harness connector (4).
  3. Install the crankcase breather hose and the clamp (2).
  4. Install the engine cover. Refer to the appropriate service article .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals