Diagnosis And Testing - Blind Spot Monitor System
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.
The following textual messages related to the Blind Spot Monitor (BSM) system may appear within the Electronic Vehicle Information Center (EVIC) display of the Instrument Cluster (IC) (also known as the Instrument Panel Cluster/IPC):
- BLIND SPOT SYSTEM OFF - This message to the vehicle operator when the ignition switch first transitions to the On status indicates that the BSM system has been turned Off using the customer programmable features function of the Radio Receiver Module (RRM) (also known as the radio or the head unit).
- SERVICE BLIND SPOT SYSTEM - This message to the vehicle operator while the ignition switch status is On indicates that the BSM system is unavailable due to a monitored system fault or faults.
- BLIND SPOT SYSTEM TEMPORARILY UNAVAILABLE
- This message to the vehicle operator while the ignition switch status is On indicates that the BSM system is temporarily unavailable as a result of one of the following:
- Sensor Blockage - The amber BSM visual icon in both outside rear view mirrors will be illuminated as long as blockage exists or until the ignition switch status transitions to Off, whichever occurs first.
- Monitored System Fault - The BSM system has detected a monitored system fault condition and has stored a Diagnostic Trouble Code (DTC). The amber BSM visual icon will be illuminated in both outside rear view mirrors for as long as the condition exists or until the ignition switch status transitions to Off, whichever occurs first.
If the BLIND SPOT SYSTEM TEMPORARILY UNAVAILABLE message is received for a minimum of 5 minutes, please verify that the outboard area at each end of the rear fascia behind the rear wheel openings where the radar sensors are located is not blocked by snow, ice or road debris. If the area is blocked, remove the blockage and verify that the message is no longer present in the EVIC display.
If the vehicle has experienced any trauma in the outboard area at each end of the rear fascia behind the rear wheel openings where the sensors are located, even if the fascia is not damaged, the radar sensor may have become misaligned. A misaligned radar sensor will result in the BSM system not operating properly.
The hard wired circuits between components related to the BSM system may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures, details of wire harness routing and retention, connector pin out information and location views for the various wire harness connectors, splices and grounds.
However, conventional diagnostic methods will not prove conclusive in the diagnosis of the BSM system or the electronic controls and communication between modules and other devices that provide some features of the system. The most reliable, efficient and accurate means to diagnose the BSM system or the electronic controls and communication related to BSM system operation requires the use of a diagnostic scan tool. Refer to DIAGNOSTIC CODE INDEX, LBSS or refer to DIAGNOSTIC CODE INDEX, RBSS .