Rear Door

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

The following test procedure applies to the rear door power window switches on all vehicles equipped with power windows, with or without power locks.

Remove the power window switch from the rear door trim panel. Refer to SWITCH, POWER WINDOW, REMOVAL .

Using an ohmmeter, test the continuity between the terminals of the rear door power window switch as shown in the Rear Door Power Window Switch Tests table.

REAR DOOR POWER WINDOW SWITCH TESTS
SWITCH POSITION	CONTINUITY BETWEEN (PINS)
NEUTRAL	1 and 4, 3 and 6
UP	2 and 4, 3 and 5
DOWN	2 and 3, 4 and 5
SWITCH ILLUMINATION	LEDs - SET MULTIMETER TO DIODE MODE - CONNECT PIN 2 TO PLUS (+), CONNECT PIN 5 TO MINUS (-) - LEDs SHOULD BARELY GLOW

If a switch fails any of the tests, replace the ineffective rear door power window switch as required.