LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System) >> Engine >> Pump, Water >> Removal >> Diesel

Pump, Water: Removal: Diesel

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    NOTE:

    Drain the fluid in a clean container, free of debris. Save the fluid for re-use.

  3. Drain the cooling system. Refer to STANDARD PROCEDURE .
  4. Remove the timing belt. Refer to the appropriate service information article .
    GC0147929Courtesy of CHRYSLER GROUP, LLC
  5. Remove the water pump mounting bolts (2).
  6. Separate the water pump (1) and the gasket from the cylinder head.
scientia non olet · About LEMON Manuals