TENSIONER, Belt: Installation: 2.4L
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not let the tensioner arm snapback to the fully extended position, severe damage may occur to the tensioner.
- Position the tensioner into place through the wheel well opening.
- Loosely install the lower bolt.
- Lower the vehicle.
- Install the upper bolt. Tighten the upper and lower bolts to
Refer to TECHNICAL SPECIFICATIONS .
- Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Install the right front wheel house splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
- Install the tire and wheel assembly.
- Connect the negative battery cable.
- Install the engine cover.