LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Fuel System) >> Fuel Injection, Diesel >> Sensor, Mass Airflow (MAF) >> Installation >> 2.2L Diesel

2.2L Diesel

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159817Courtesy of CHRYSLER GROUP, LLC
  1. Install the Mass Air Flow (MAF) sensor (1) into air cleaner body and securely tighten the screws (2).
    GC0170041Courtesy of CHRYSLER GROUP, LLC
  2. Install the air tube (4) and securely tighten the clamps (2, 5).
  3. Connect the MAF sensor wire harness connector (1) and attach wire harness (3) to the air tube (4).
  4. Install the engine cover. Refer to the appropriate service information article .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.


GC0159817Courtesy of CHRYSLER GROUP, LLC
  1. Install the Mass Air Flow (MAF) sensor (1) into air cleaner body and securely tighten the screws (2).
    GC0170041Courtesy of CHRYSLER GROUP, LLC
  2. Install the air tube (4) and securely tighten the clamps (2, 5).
  3. Connect the MAF sensor wire harness connector (1) and attach wire harness (3) to the air tube (4).
  4. Install the engine cover. Refer to the appropriate service information article .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals