LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Fuel System) >> Fuel Injection, Diesel >> Sensor, Crankshaft Position >> Removal

Sensor, Crankshaft Position: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    GC0147937Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the Crankshaft Position Sensor (CKP) wire harness connector (3).
  5. Remove the bolt (2) the CKP sensor (1).
scientia non olet · About LEMON Manuals