2.0L Diesel
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
No sparks, open flames or smoking. Risk of poisoning from inhaling and swallowing fuel. Risk of injury to eyes and skin from contact with fuel. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the engine cover. Refer to the appropriate service information article.
.
- Remove the fuel injection pump insulator (1).
- Disconnect the fuel quantity solenoid wire harness connector (2).CAUTION:
Counter hold union connections with a wrench and DO NOT EXCEED the recommended tightening torque in order to avoid also loosening the threaded connection between the union and the fuel injection pump.
- Unscrew the union nuts (1) at the fuel rail.
- Using a wrench to counter hold fitting, unscrew the union nut (3) from the fuel injection pump outlet port and discard the fuel tube (2).
- Remove the fasteners (2) and the fuel quantity solenoid (1).