LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (3.2L Engine (Service Information)) >> Lubrication >> Pick-Up, Oil Pump >> Installation

Pick-Up, Oil Pump: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0157474Courtesy of CHRYSLER GROUP, LLC
  1. Lightly lubricate the new O-ring seal with engine oil and install on the oil pick-up tube.
  2. Install the oil pick-up tube (1) and tighten the bolt (3) to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  3. Install the oil pan. Refer to PAN, OIL, INSTALLATION .
  4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to STANDARD PROCEDURE  .
  5. Run the engine until it reaches normal operating temperature.
scientia non olet · About LEMON Manuals