LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (3.2L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Removal

Damper, Vibration: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0144221Courtesy of CHRYSLER GROUP, LLC
  1. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
    NOTE:

    A force greater than 350 N.m (260 ft. lbs.) may be required to remove the crankshaft vibration damper bolt.

  2. Hold the crankshaft vibration damper (1) with Vibration Damper Holder (special tool #10198, Holder, Vibration Damper) (2) and remove the crankshaft vibration damper bolt.
  3. Pull the crankshaft vibration damper (1) off of the crankshaft.
scientia non olet · About LEMON Manuals