Damper, Vibration: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Apply a light coating of engine oil to the front crankshaft seal surface (1).
- Align the crankshaft vibration damper (1) to the flywheel key on the crankshaft and install the damper. Seat the damper on the crankshaft sprocket.
- Install and hand tighten the crankshaft vibration damper bolt (2).
- Hold the crankshaft vibration damper (1) with Vibration Damper Holder (special tool #10198, Holder, Vibration Damper) (2) and tighten the crankshaft vibration damper bolt to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .