On Vehicle
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, install the spring seat and valve guide seal over the valve guide. Refer to SEAL(S), VALVE GUIDE, INSTALLATION .NOTE:
Make sure that the valve spring is intact around the top of the valve guide seal.
NOTE:If the valve springs are being reused, reassemble them into their original locations. Number 5 cylinder exhaust valve spring shown in illustration, all other valves similar.
- Install the valve spring (2) and valve spring retainer (1).NOTE:
Number 4 cylinder intake valve spring compression shown in illustration, all other valves similar.
- Compress the valve springs (4) with the Valve Spring Compressor Adapter 10224 (3) mounted in the Valve Spring Compressor C-3422-D (2).
- Install the valve retaining locks (5) and release the valve spring compressor.
- Relieve the air pressure from the combustion chamber and remove the spark plug adapter (1).
- Install the spark plug. Refer to SPARK PLUG, INSTALLATION
.NOTE:
If the rocker arms are being reused, reassemble them into their original locations.
- Install the rocker arm(s). Refer to ROCKER ARM, VALVE, INSTALLATION .