LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (3.2L Engine (Service Information)) >> Cylinder Head >> Lifter(S), Hydraulic >> Removal

Lifter(S), Hydraulic: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The LH cylinder head hydraulic lifters are shown, the RH cylinder head hydraulic lifters are similar.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the camshaft(s). Refer to CAMSHAFT, ENGINE, REMOVAL .
    NOTE:

    If the rocker arms are to be reused, identify their positions so that they can be reassembled into their original locations.

  3. Remove the rocker arm(s). Refer to ROCKER ARM, VALVE, REMOVAL .
    GC0144235Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    If the hydraulic lifters are to be reused, identify their positions so that they can be reassembled into their original locations.

  4. Remove the hydraulic lifter(s) (1).
scientia non olet · About LEMON Manuals