LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Rear Suspension) >> Link, Toe >> Installation

Link, Toe: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159361Courtesy of CHRYSLER GROUP, LLC
  1. Position the toe link (2) and install a NEW  toe link to knuckle mounting bolt (3) and a NEW  toe link to knuckle mounting nut. Do not tighten.
  2. Install a NEW  toe link to cradle mounting bolt and a NEW  toe link to cradle mounting nut (1). Do not tighten.
  3. Using a suitable holding fixture, support the outboard end of the spring link and lift it to normal ride height.
  4. Tighten the toe link to knuckle mounting nut to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
    NOTE:

    Position the cam as close to removal marking as possible to aid in alignment.

  5. Tighten the toe link to cradle mounting nut (1) to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  6. Remove the spring link holding fixture.
  7. Install the wheel. Refer to INSTALLATION .
  8. Remove the support and lower the vehicle.
  9. Perform an alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals