LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Rear Suspension) >> Link, Camber >> Installation

Link, Camber: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159875Courtesy of CHRYSLER GROUP, LLC
  1. Position the camber link (1) and install the camber link to knuckle mounting bolt and the camber link to knuckle mounting nut (2), do not tighten.
  2. Install the camber link to cradle mounting bolt (2) and the camber link to cradle mounting nut, do not tighten.
  3. Using a suitable holding fixture, support the outboard end of the spring link and lift it to normal ride height.
  4. Tighten the camber link to knuckle mounting nut to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  5. Tighten the camber link to cradle mounting nut to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  6. Remove the spring link holding fixture.
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals