LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating & Air Conditioning (Service Information)) >> Plumbing >> Tube, Condensation Drain >> Removal

Tube, Condensation Drain: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the right side center console closeout from the center console.
    GC0155569Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect clamp (4) and remove the condensation drain tube (2) from the HVAC housing (1).
  4. Remove the condensation drain tube from the floor panel (3).
scientia non olet · About LEMON Manuals