LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating & Air Conditioning (Service Information)) >> Distribution >> Motor, Blower >> Removal

Motor, Blower: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the passenger side silencer panel. Refer to PANEL, SILENCER, LOWER, REMOVAL .
  3. Remove the passenger side center console close out.
  4. Remove the blower motor power module

    Refer to MODULE, POWER, BLOWER MOTOR, REMOVAL .

    GC0159920Courtesy of CHRYSLER GROUP, LLC
  5. Remove the three screws (1) that secure the blower motor.
  6. Remove the blower motor from the passenger side of the HVAC housing.