LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating & Air Conditioning (Service Information)) >> Controls >> Transducer, A/C Pressure >> Removal

Transducer, A/C Pressure: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

GC0082715Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C pressure transducer shown in illustration.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) on the A/C discharge line (3).
  3. Remove the A/C pressure transducer from the A/C discharge line and remove and discard the O-ring seal (4).
scientia non olet · About LEMON Manuals