LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating & Air Conditioning (Service Information)) >> Controls >> Control, A/C And Heater >> Installation

Control, A/C And Heater: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0155712Courtesy of CHRYSLER GROUP, LLC
  1. Position the A/C heater control (3) to the instrument panel (4) and connect the HVAC wire harness connector (1).
  2. Position the A/C heater control to the instrument panel and engage the retaining tabs (2). Make sure the retaining tabs are fully engaged into the instrument panel.
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  4. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals