Insulator, Engine Mount, Rear: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
If equipped, remove the skid plate. Refer to PLATE, SKID, TRANSMISSION, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Do not reuse the torque strut (rear engine mount) to cradle nut (2). If removed, a new fastener must be installed and tightened to specifications.
Remove and discard the torque strut (rear engine mount) to cradle nut (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the torque strut bolt (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the torque strut to transmission bracket through bolt and nut (4).
Position the engine forward to allow the torque strut to be removed from the torque strut bracket (5).
NOTE:
The exhaust system can remain intact. Carefully pry the engine forward enough to clear the bracket but not to overextend the exhaust hangers.
Remove torque strut (rear engine mount) (3).