LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (2.4L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle

    .

  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  3. Lower the vehicle.
  4. Remove the engine cover to prevent contact with the cowl.
  5. Remove the battery and tray. Refer to TRAY, BATTERY, REMOVAL .
  6. Remove the PDC. Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL .
  7. Position the PDC harness loom aside.
  8. Support transaxle with a suitable jack.
    GC0159271Courtesy of CHRYSLER GROUP, LLC
  9. Remove the two mount to frame rail bolts (3).
  10. Remove the three mount to transaxle bracket bolts (5).
    GC0156133Courtesy of CHRYSLER GROUP, LLC
  11. Loosen, but do not remove the bolt (2) for the trans mount (3) to strut tower (1) attachment.
    GC0159271Courtesy of CHRYSLER GROUP, LLC
  12. Remove the mount (4).
scientia non olet · About LEMON Manuals