LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (2.4L Engine (Service Information)) >> Cylinder Head >> Seal(S), Valve Guide >> Installation

Seal(S), Valve Guide: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Reassemble the valves into their original locations. If the valves or valve seats have been refinished, verify that the valve stem tip height is within specification. Refer to ENGINE SPECIFICATIONS  .

  1. If removed, install the valve(s). Refer to INSTALLATION  .
    NOTE:

    Valve spring seats are integral to the stem seal and are common Intake and exhaust.

  2. If removed, install the spring seat over the valve guide.
  3. Apply engine oil to the lip of the valve guide seal (3). Install the valve guide seal (3) over the valve stem. Using an appropriate driver (1), push the seal firmly and squarely over the valve guide. Do Not Force  the seal against the top of guide.
    NOTE:

    Make sure that the garter spring is intact around the top of the valve guide seal.

    NOTE:

    If the valve springs are being reused, reassemble them into their original locations. Intake and exhaust springs are unique.

  4. Install the valve spring(s). Refer to SPRING(S), VALVE, INSTALLATION  .
scientia non olet · About LEMON Manuals