LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Exhaust System) >> Sensor, Exhaust Temperature >> Removal >> 2.2L Diesel EGT Sensor 1/4

2.2L Diesel EGT Sensor 1/4

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    GC0169969Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Exhaust Gas Temperature (EGT) sensor 1/4 wire harness connector (1) and detach the connector from bracket.
    GC0169918Courtesy of CHRYSLER GROUP, LLC
  4. Open the retaining clip and remove the wires from retainer clip (1).
    GC0169938Courtesy of CHRYSLER GROUP, LLC
  5. Remove the EGT sensor 1/4 (1) from the Diesel Oxidation Catalyst (DOC)/Diesel Particulate Filter (DPF).
scientia non olet · About LEMON Manuals