LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Exhaust System) >> Sensor, Exhaust Temperature >> Installation >> 2.0L Diesel EGT Sensor 1/1

2.0L Diesel EGT Sensor 1/1

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0153964Courtesy of CHRYSLER GROUP, LLC
  1. Install the Exhaust Gas Temperature sensor 1/1 (5) and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  2. Attach the EGT sensor 1/1 wire harness connector (3) to bracket (4).
  3. Attach the EGT sensor 1/1 wire (1) to heat shield (2).
    GC0153959Courtesy of CHRYSLER GROUP, LLC
  4. Connect the EGT sensor wire harness connector (1).
    GC0157479Courtesy of CHRYSLER GROUP, LLC
  5. Install the engine cover (1).
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals