LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Exhaust System) >> Sensor, Differential Pressure >> Removal

Sensor, Differential Pressure: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the engine cover. Refer to the appropriate article. .
    GC0159583Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the differential pressure sensor wire harness connector (3).
  4. Disconnect the differential pressure sensor vacuum hoses (4).
  5. Remove the nut (1) and differential pressure sensor (2).
scientia non olet · About LEMON Manuals