Solenoid Valves Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Place the valve body on a clean work surface supported on each end by wooden blocks with the upper half facing upward.
- Insert the park lock solenoid into the bore in the outer valve body.
- Insert the solenoids (3) straight into their respective bores in the outer valve body (2).NOTE:
Lubricate the solenoid O-rings with a light coating of assembly lube to prevent seal damage.
- Test fit the wire connector (1) into the solenoid connectors (2) to assure alignment.
- Remove the wire connector with care not to rotate the solenoids.
- Position the valve body so the inner valve body is on top.
- Place the large solenoid retaining plate (1) in position on the valve body with the index tabs (3) on the retainer in the notches (2) on the center dog clutch solenoids.
- Place the small solenoid retaining plate (1) in position on the valve body.
- Install the screws (1) to hold the solenoid retaining plates to the outer valve body and tighten to the proper torque specification. Refer to VALVE BODY, INSTALLATION .
- Install the valve body in the transmission. Refer to VALVE BODY, INSTALLATION .
- Perform Transmission Verification Test-948TE. Refer to TRANSMISSION VERIFICATION TEST .