Reaction Shaft Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the reaction shaft with suitable solvent and blow it dry using regulated 344 kPa (50 psi) shop air.
- Inspect the reaction shaft for excess damage or ware. Replace the reaction shaft if damage is present.
- Install a NEW
seal ring (1) in the land of the outer reaction shaft hub (2).
- Install NEW
seal rings (1) in the lands of the inner reaction shaft hub (2).
- Place the reaction shaft (2) into the intermediate support plate (1).
- Install the bolts (2) to hold the reaction shaft (1) to the intermediate support plate (4) and tighten to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the bellhousing on the transmission. Refer to BELLHOUSING, INSTALLATION .
- Install the transmission in the vehicle. Refer to INSTALLATION .