Fwd Both Sides - 4WD / AWD Left Side
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the halfshaft from the vehicle. Refer to REMOVAL
.NOTE:
Keep the punch tool in the center of the seal to avoid damage to the transmission housing.
- Using a suitable punch tool (1) and hammer, punch a hole in the metal armature inside the seal (2).
- Thread the sheet metal screw of the dent puller (2) into the seal (1).
- Tap outward on the slide hammer (2) until the seal (1) comes out of the seal bore.