LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Automatic Transmission (Service Information)) >> Harness, Internal Wire >> Installation

Harness, Internal Wire: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the internal transmission wire harness onto on the valve body.
  2. Tighten the solenoid wire harness connector screws to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
  3. Connect the wire harness connector to the transmission fluid pressure transducer.
  4. Install the valve body. Refer to VALVE BODY, INSTALLATION .
  5. Perform Transmission Verification Test-948TE. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
scientia non olet · About LEMON Manuals