LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Automatic Transmission (Service Information)) >> Cable, Shift >> Adjustments >> Verification

Cable, Shift: Adjustments: Verification

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place gearshift lever in Park (P).
  2. Attempt to move vehicle by rocking back and forth on level ground. If vehicle does not move, attempt to start engine. If engine starts, the park position is correct.
  3. Set parking brake.
  4. Turn key to on/run and depress brake pedal. Place gearshift lever in Neutral (N).
  5. Attempt to start engine. If engine starts in both Neutral (N) or Park (P), gearshift cable is adjusted properly. No adjustment is required.
  6. If engine does not start in either Park (P) or Neutral (N), perform adjustment procedure.
scientia non olet · About LEMON Manuals