Differential Bearing Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Remove the transmission from the vehicle. Refer to REMOVAL .
Position the transmission on a suitable, clean work surface.
Remove the bellhousing. Refer to BELLHOUSING, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the differential unit from the transmission.
Clean the differential unit with solvent and blow it dry with regulated 344 kPa (50 psi) shop air.

Courtesy of CHRYSLER GROUP, LLC

NOTE:

If the differential is assembled, remove the bearings using the following tools and procedure.

Using tools (special tool #9738, Blocks, Adapter) (2), and (special tool #8513A, Insert, Crankshaft) (3), along with (special tool #C-293-PA, Puller, Press) (1) remove the side bearings.

If the Differential is Disassembled remove the bearings using following tools and procedure.

Courtesy of CHRYSLER GROUP, LLC

Using tools (special tool #C-293-37, Block Set, Puller) (2), and (special tool #9678, Press Plug) (3), along with (special tool #C-293-PA, Puller, Press) (1) remove the side bearing (4).