LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Automatic Transmission (Service Information)) >> Bearings, Differential >> Removal >> Differential Bearing Race Removal

Differential Bearing Race Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission from the vehicle. Refer to REMOVAL .
  2. Position the transmission on a suitable, clean work surface.
  3. Remove the bellhousing. Refer to BELLHOUSING, REMOVAL .
    GC0159764Courtesy of CHRYSLER GROUP, LLC
  4. Using tool (special tool #9664, Remover, Bearing Cup) (2), (special tool #C-637, Slide Hammer, Universal) (1) and suitable vise-grip pliers (3) to hold the expansion screw in position, remove the bearing race (4) from the bellhousing.
    GC0159469Courtesy of CHRYSLER GROUP, LLC
  5. Remove the differential unit (1) from the transmission.
    GC0159899Courtesy of CHRYSLER GROUP, LLC
  6. Using tool (special tool #9664, Remover, Bearing Cup) (2), (special tool #C-637, Slide Hammer, Universal) (1) and suitable vise-grip pliers (3) to hold the expansion screw in position, remove the bearing race (4) from the transmission housing.
scientia non olet · About LEMON Manuals