Differential Bearing Race Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

If only the bearing is being replaced the bearing preload does not require selecting a new select shim. If the transmission housing, bellhousing or differential is replaced, the proper thickness select shim will have to be determined. Refer to STANDARD PROCEDURES .

Wipe the bearing bores clean with a clean lint free cloth.
Inspect the bearing bores for damage or cracks in the casting.

Courtesy of CHRYSLER GROUP, LLC
Install the original select shim in the bearing bore of the transmission housing.

Courtesy of CHRYSLER GROUP, LLC
Place the NEW bearing race in the bearing bore of the transmission housing.

Courtesy of CHRYSLER GROUP, LLC
Using tool (special tool #C-4310, Installer, Bearing) (2) and (special tool #C-4171, Driver Handle, Universal) (1) install the bearing race in the transmission housing.

Courtesy of CHRYSLER GROUP, LLC
Install the differential unit (1) in the transmission housing.
Place the NEW bearing race in the bearing bore of the bellhousing.
Using tool (special tool #C-4310, Installer, Bearing) and (special tool #C-4171, Driver Handle, Universal) install the bearing race in the transmission bellhousing.
Install the bellhousing. Refer to BELLHOUSING, INSTALLATION .
Install the transmission in the vehicle. Refer to INSTALLATION .
Road test the vehicle to verify the repair.