Differential Bearing Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

If only the bearing is being replaced the bearing preload does not require a new select shim. If the transmission housing, bellhousing or differential is replaced, the proper thickness select shim will have to be determined. Refer to STANDARD PROCEDURES .

Clean the differential unit with solvent and blow it dry with regulated 344 kPa (50 psi) shop air.

Courtesy of CHRYSLER GROUP, LLC
Using a suitable hammer (1), (special tool #6888, Installer, Seal) (3) and (special tool #C-4171, Driver Handle, Universal), install the side bearings.
If necessary, assemble the differential unit. Refer to DIFFERENTIAL AND RING GEAR, ASSEMBLY .

Courtesy of CHRYSLER GROUP, LLC
Install the differential assembly (1) into the transmission housing.
Install the bellhousing. Refer to BELLHOUSING, INSTALLATION .
Install the transmission in the vehicle. Refer to INSTALLATION .