LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Starting System (Service Information)) >> Starter >> Removal >> 3.2L

Section 26 (Starting System (Service Information)): Starter: Removal: 3.2L

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159241Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle.
  3. Remove the catalytic converter (3). Refer to CONVERTER, CATALYTIC, REMOVAL, 3.2L .
    GC0144659Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the starter solenoid electrical connector (1) from the starter solenoid terminal.
  5. Remove the battery cable nut and battery cable from the solenoid stud (2).
  6. Remove the starter mounting bolts (4).
  7. Remove the starter assembly (3) from the transmission.
scientia non olet · About LEMON Manuals