Antenna, Remote Start: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the RSA (2) to its mounting surface and secure the antenna using two fasteners (1).
Connect the RSA (3) to the Radio Frequency Hub (RF-Hub) (4).
Install the headliner. Refer to HEADLINER, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.