Shield, Underbody: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Right side shown, left side typical.
- Position the underbody shield (1) to the vehicle.
- Install the two retaining nuts (3) that secure the underbody shield (1) to the vehicle underbody (2) and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
- Install the two push pin fasteners (4) that secure the underbody shield (1).
- Install the seven fasteners that secure the underbody shield (1) to the vehicle underbody (2). Tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
- Lower the vehicle.