Trip Computer

Press and release the UP  and DOWN  arrow button until one of the following Trip Functions displays in the EVIC:

• Average Fuel Economy
• Distance
• Elapsed Time
• Display Units of Measure in

Press the LEFT  or RIGHT  button to cycle through all the Trip Computer functions.

The Trip Functions mode displays the following information:

• Average Fuel Economy  Shows the average fuel economy since the last reset. When the fuel economy is reset, the display will read "RESET" or show dashes for two seconds. Then, the history information will be erased, and the averaging will continue from the last fuel average reading before the reset.
• Distance To Empty (DTE)  Shows the estimated distance that can be traveled with the fuel remaining in the tank. This estimated distance is determined by a weighted average of the instantaneous and average fuel economy, according to the current fuel tank level. DTE cannot be reset through the OK  button. When the DTE value is less than 30 miles (48 km) estimated driving distance, the DTE display will change to a text display of "LOW FUEL." This display will continue until the vehicle runs out of fuel. Adding a significant amount of fuel to the vehicle will turn off the "LOW FUEL" text and a new DTE value will display.
• Elapsed Time  Shows the total elapsed time of travel since the last reset when the ignition switch is in the ACC position. Elapsed time will increment when the ignition switch is in the ON or START position.
• Display Units of Measure in:  To make your selection, press and release the OK  button until "US" or "METRIC" appears.

To Reset The Display  Reset will only occur while a reset function is being displayed. Press and release the OK  button once to clear the reset function being displayed. To reset all reset functions, press and hold the OK  button a second time within 3 seconds of resetting the currently displayed function (>Reset ALL will display during this 3 second window).