LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Installation >> Center Floor Console

Center Floor Console

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0156095Courtesy of CHRYSLER GROUP, LLC
  1. Position the Low Frequency (LF) antenna (1) to the bracket beneath the front of the center floor console.
  2. Install and tighten the two screws that secure the antenna to the bracket beneath the front of the console. Tighten the screws securely.
  3. Connect the wire harness connector to the antenna connector receptacle.
  4. Install the console into the vehicle. Refer to CONSOLE, FLOOR, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals